Philips NP2900-37B - Manual (Page 8)

6
B
This icon indicates steps on your remote control!
Connect the player to the power supply
Connect the player to the power supply as shown in the diagram on page 4.
After a short introduction demo, the player prompts you to select the location.
Select the location / time zone and confirm. 1
The player shows the prompt for the network connection. >
2 Select [Yes], to create a connection to the network.
The player shows the prompt for the network setup (if no network >
has been set up yet).
• Select [no] to exit the setup and go to the Home menu.
Connect the player to a home network
Here is how to create a wireless connection to your home network with
broadband Internet access
The onscreen display guides you through the process of connecting the player. This
section describes the typical wireless setup with automatic IP address. For information
on different setups, consult the user manual.
Ensure that your network name and network password or encryption key are 1
available.
Turn on your wireless access point or wireless router with broadband Internet access. 2
3 Follow the steps in section (A) and select [Yes], to create a connection to the
network.
Select [ 4 Wireless (WiFi)] to start the network setup process.
For wireless routers with Wi-Fi protection system (WPS) that supports push •
button configuration (PBC): On the router, press the WPS PBC push button (often
displayed as ) to activate. On NP2900 press OK to confirm.
For wireless routers with Wi-Fi protection system (WPS) that supports a personal •
identification number (PIN): On NP2900 select WPS PIN, then enter the displayed
PIN on the router.
For other wireless routers: •
NP2900 searches for networks. >
Use the remote
control.
A
np2900_qsg_37_01eng.indd 6 3/20/2009 5:17:10 PM