Bushnell Legend 98-1404/03-09 - Manual (Page 5)

5
USING THE ZOOM EYEPIECE
Rotate the zoom ring on the eyepiece to change magnifying power from low to high. Lower power settings
will provide a brighter image with a wider field of view, higher powers allow observing smaller details on
more distant subjects. To reduce the need to readjust focus when zooming, set the zoom to its highest
power and focus on your subject. When you zoom back down to lower powers, it will stay in focus.
Note: the zoom eyepiece is not removable, do not attempt to take it off of the scope.
USING THE EYECUP AND LENS SHADE
If you are not wearing glasses, twist the rubber eyecup counter-clockwise to extend it. If you experience
glare or lens flare due to the angle and direction of the sun relative to the front lens, pull the lens shade
out to extend it.
USING THE SCOPE GLOVE
(not included with 80mm models)
A scope glove is included with some smaller Legend Ultra HD scopes, to allow convenient handheld
viewing at low magnification settings (15-20x range). Pull the wide straps away from their velcro tabs and
place the glove on the scope, making sure the tripod mount goes through the opening at the bottom, then
put the straps back in place on the velcro tabs. Slip your hand through the side strap and use the buckle
to adjust the strap length so it holds the scope tightly against your hand.
NEVER LOOK DiRECtLY At tHE SUN WitH YOUR SCOPE
AS it MAY CAUSE SERiOUS DAMAGE tO YOUR EYES