Philips DVP5982C1-37 - Manual (Page 54)

English
54
Problem Solution
Troubleshooting
(continued)
The contents of the USB fl ash drive
cannot be read
Slow operation of the USB fl ash
drive
No HDMI video output
No HDMI audio output
– The USB fl ash drive format is not compatible with the
DVD player.
– Drive is formatted with a different fi le system. (e.g.
NTFS)
– Big fi le size or high solution USB fl ash driver takes longer
time to read and display on the TV screen.
– HDMI connection can only be made to HDMI-equipped
devices with HDCP (High Bandwidth Digital Content
Protection). Use a separate adaptor (DVI to HDMI) for
DVI TV connection (equipped with HDCP).
– Make sure the resolution of this DVD player matches the
TV device you have connected using the HDMI;
480p/576p/720p/1080i/1080p and this DVD player
supports 1080p at 50/60Hz only.
– When connecting to a non-HDCP complaint TV, the
HDCP warning message will appear.
– When the HDMI and RGB video connection are used at
the same time, there will be no picture output from the
RGB video connection, disconnect the HDMI cable.
– Press HD UPSCALE if no picture on the TV screen after
power off and on.
– Check the connection between the TV and HDMI of
DVD player.
– During resolution selection for DVI TV, a distorted or
black screen may appear, see HDMI Video Setup.
– There will be no sound from the HDMI output if the
source device is only DVI/HDCP (High Bandwidth Digital
Content Protection)- compatible.
– It is not possible to output SACD or copy-controlled
DVD audio sources from the HDMI connection.
1_dvp5982MKII_37_eng 2.indd 54 1_dvp5982MKII_37_eng 2.indd 54 2007-08-20 5:03:07 PM 2007-08-20 5:03:07 PM