Broilmaster AND P48 - Manual (Page 9)

Attach the Rear Brace (16) to the Left and
Right Side Assemblies with four ˘-20 x 3/4
screws (15). Figure 4.
Important: Completely tighten all screws
at this time.
4
C
ART
A
SSEMBLY
7
4
2
15
F
IGURE
5
Install one 1/4-20 x 3/4 phillips screw (15) into
the factory installed nut on the Left Side Assembly.
Fasten the Cylinder Retainer (4) to the screw with
a wing nut (2). Adjust height to accommodate
your LP cylinder. Figure 5.
5
Slide the flanges of the Control Housing (5) behind
the opening. Allow the Control Housing to rest at
the bottom of the opening. Figure 6.
6
F
IGURE
6
F
IGURE
4
15
16