Philips Norelco AquaTouch Series 4000 wet & dry electric shaver AT811 DualPrecision heads Flex & Float system 50 min shaving 1 hour charge AquaTech wet & dry technology with Aquatec wet and dry and Pop-up trimmer User Manual

Page 11

ENGLISH

After Each Use: Trimmer

Turn razor OFF.

Push down spring-release trimmer switch.

Clean trimmer with the short-bristled side

of the brush every time you use it. Brush

up and down along the trimmer teeth.

Lubricate the trimmer teeth with one

drop of mineral oil every 6 months.

Close trimmer by pressing trimmer down.

Replacing the Razor Heads

Replace the razor heads once a year for

optimal shaving results.

Replace damaged or worn razor heads with

model HQ8 Philips Norelco razor heads only.

Clean the inside and outside of the comb

with the brush supplied.

For optimum performance, razor cutters and

combs should be cleaned in a degreasing liquid

(e.g. Philips Norelco Shaving Head Cleaning Spray,

Model HQ110 or alcohol) and lubricated with

one drop of mineral oil (in the center of the

head). This helps prevent wear of the shaving

heads.

Replace the set back into the Razor Head

Assembly.

Make sure that the two pointy edges of the

head fit exactly into the recesses.

Repeat the process for the other two sets

of cutters and combs.

Replace the frame and turn the lock

clockwise until it locks into place.

Insert the notch of the shaving unit into

the slot in the top of the razor (1) and

then close the shaving unit (2).

NOTE: If the shaving unit does not close smoothly,

make sure you inserted the shaving heads

properly and that the retaining frame is locked.

Put the Protective Cap on razor to protect

heads.