Bushnell 78-7348 - Manual (Page 7)

12
USING THE TRIPOD
To pan side to side or up and down, unloosen the tripod control handle by rotating it
counterclockwise. To lock into a desired position, rotate the tripod control handle clockwise.
CAUTION: DO NOT LOOK AT THE SUN THROUGH THIS SPOTTING
SCOPE AS SEVERE DAMAGE TO YOUR EYES MAY RESULT!
CARE
The lenses of your spotting scope are coated for highest light transmission. As with any coated
optics, special care must be taken in cleaning the lenses. Moisten the surface of the lens slightly
and wipe dry using a circular motion starting at the center of the lens. Wipe or brush off any
dirt or dust on the outside of the spotting scope.
CAUTION
Never disassemble your spotting scope. Special tools and equipment are required for service and
irreparable damage can result from untrained attempted service. Unauthorized service may also
void the warranty.
11
SPOTTING SCOPE INSTRUCTIONS
MOUNTING
Remove the spotting scope from the packaging. Attach the tripod
with the provided screw to the tripod mount hole located on the
base of the spotting scope. Spread the tripod legs and set on a
solid surface.
MAGNIFICATION
To "zoom" the spotting scope, grasp and rotate the variable
magnification ring to change power. The magnification ring is
located on the eyepiece. When rotating this ring, the image will
increase or decrease in apparent size. It may be necessary to re-
focus when the magnification is changed.
FOCUSING
The focus ring is located in front of the eyepiece, towards the
middle of the spotting scope body. By turning this adjustment, the
image will sharpen until in focus.