Bushnell 78-7348 User Manual

Page 5

15. If "Delete Last" mode is selected, the display will show the following:

Press

SNAP to delete the last picture from the camera’s memory.

16. If "Delete All" mode is selected, the word "ALL" appears next to the icon on the

display. To delete all pictures in the camera’s memory, select this mode. The picture

number will then blink. Press and hold the

SNAP button. You will hear a tone that

becomes higher as the pictures are deleted. Once complete, the picture number

will reset to zero. If no button is pressed for a while, the camera returns to stand-by.

17. If the "Battery" indicator is only one third highlighted, it is necessary to replace the

batteries soon.

12. To enter "Low Resolution" mode, which will cause your

pictures to be of a lower resolution, but will also allow you to

store many more pictures in the camera’s memory, press the

MODE button 3 times until you see the "LQ" icon blinking.

Press the

SNAP button to select this mode. The "Low" icon

will then stop blinking. Entering this mode later and pressing

SNAP again will return you to "High Resolution" mode.

13. When in "Normal" mode press the

MODE button 4 times to enter the "AVI"

mode. The " " icon will begin to blink. Press the

SNAP button to select this

mode. The " " will then stop blinking. Holding down the

SNAP button will

take AVI clips as long as you continue to depress the button or until the memory

is full. Once you release the button the camera will revert back to "Normal" mode

so you can take still (i.e. non-action) pictures again as long as there is unused

memory left. Repeat step 11 if you want to change the camera to the AVI mode again.

14. You can chose between the 50mhz and 60mhz settings for the camera output.

The camera’s default mode is the "60" mode, which matches the power frequency

for the United States. To change to the "50" mode, press the

SNAP button until

the "60" changes to "50." Confirm the selection by pressing the

SNAP button. To

avoid any flickering on the picture, the correct power frequency (either 50 or 60)

for your country must be selected.

delete last picture then quit this mode

the " " icon will blink and buzzer will sound