Connecting the power cord, Remote control battery installation, Ntsc/pal settings – Philips DVD711AT98 User Manual
Page 18: Loading the batteries, Dolby surround sound, Open the battery compartment cover
18 PREPARATION
Connecting to an amplifier equipped with Dolby
Surround™
Dolby Surround sound
1
Connect the player to the TV, then connect the player’s audio Left and
Right out jacks to the corresponding in jacks on the Dolby Surround™
Audio/Video receiver, using the audio/video cable supplied (C).
If your amplifier is equipped with a Dolby Digital™ decoder,
● Connect the player as described in ‘Connecting to an A/V receiver with
multi-channel decoder’.
If your TV is equipped with a Dolby Surround™ decoder,
● Connect the player to the TV as described in ‘Connecting to a TV’.
Connecting the power cord
1
Plug the female end of the supplied power cord into the Mains (AC) jack
on the rear of the player.
2
Connect the other end of the cord to an AC outlet.
Note: When the player is in the “STANDBY” mode, it is still consuming some
power. If you wish to disconnect your player completely from the power, press
POWER ON/OFF
Caution: Only qualified service personnel should remove the
cover or attempt to service this device.
Remote control battery installation
Loading the batteries
1
Open the battery compartment cover.
2
Insert batteries as indicated inside the battery compartment.
3
Close the cover.
Caution: Do not mix old and new batteries. Never mix
different types of batteries (standard, alkaline, etc.).
NTSC/PAL Settings
You can switch the NTSC/PAL setting of the DVD player to match the
video signal of your TV.This setting only affects the television’s on-screen
display that shows the stop and setup modes.You may select either
NTSC or PAL.To change the DVD player setting to PAL or NTSC,
follow the steps below.
1
Press the POWER ON/OFF button on the front panel of the DVD
player to turn OFF the DVD player.
2
Press and hold 9 and T on the front of the DVD player.While
holding 9 and T, press POWER ON/OFF.
3
After PAL or NTSC appears on the display panel of the DVD player,
release 9 and T at the same time.The PAL or NTSC that appears on
the display panel indicates the current setting.
4
To change the setting, press T within three seconds.The new setting
(PAL or NTSC) will appear on the display panel.
+
-
+
-
L
R
CVBS
VIDEO OUT
COAXIAL
AUDIO
Y
S-VIDEO
OPTICAL
1
DIGITAL AUDIO OUT
PCM/MPEG2/AC3/DTS
1
2
2
CB
CR
MAINS
TV
C
B
A