Philips DVDR3545V-37 - Manual (Page 15)

15 EN 15 EN
Recording
Playback
Editing
Introduction
Connections
Basic Setup
Function Setup
VCR Functions
Others
ANTENNA CABLE CONNECTION
This section describes how to connect your unit to an antenna, cable box, etc.
* Once connections are completed, turn on the TV and
begin initial setting.
Channel scanning is necessary for the unit to memorize
all available channels in your area.
(Refer to “INITIAL SETTING” on page 26.)
Note
• For your safety and to avoid damage to the device, please unplug the RF coaxial cable from the ANTENNA IN jack
before moving the unit.
• If you use an antenna to receive analog TV, it should also work for DTV reception. Outdoor or attic antennas will be
more effective than set-top versions.
• Antenna out is for tuner pass through only. DVD playback through the RF is not possible.
4 Plug in the power cord of this unit and your TV to the AC outlet.
1 Disconnect the power cord of your TV from the AC outlet.
2 Disconnect RF coaxial cable from antenna input jack of your TV.
3 Connect cables to the unit.
Make the basic connection as illustrated below.
Supplied cables used in this connection are as follows:
• RF coaxial cable x 1
• RCA audio cable (L/R) x 1
• RCA video cable x 1
Please purchase the rest of the necessary cables at your
local store.
rear of your TV
rear of this unit
connect
ANT. IN
VHF / UHF
antenna
cable TV
company
RF coaxial cable
or
rear of your TV
disconnect
disconnect
1 1 1
2
HDMI OUT
DVD DIGITAL AUDIO OUT AUDIO OUT S-VIDEO
IN
COAXIAL
L Y
P B /C B
P R /C R
R
L
R
OUT
IN
S-VIDEO IN --- AUDIO --- OUT
IN --- VIDEO --- OUT
COMPONENT VIDEO OUT
DVD/VCR
ANTENNA
rear of this unit
AUDIO IN
L R
VIDEO IN
rear of your TV
This connection is for
TV loop through only
OUT
IN
ANTENNA
IN
L
R
S-VIDEO IN --- AUDIO --- OUT
IN --- VIDEO --- OUT
DVD/VCR
VHF / UHF
antenna
cable TV
company
RF coaxial
cable
or
ANT. IN
RF coaxial cable
RCA audio
cable
RCA video
cable
E9H90UD.indd 15 E9H90UD.indd 15 2007/05/16 15:43:54 2007/05/16 15:43:54