Philips 8020X-33 - Manual (Page 10)

ENGLISH
may dent or damage precision-made slotted
combs.
◗ Do not use razor if combs are damaged or
broken. Facial injury may occur.
◗ Never dry the shaving unit with a towel or
tissue as this may damage razor heads.
◗ Do not use abrasives, scourers or liquids such
as acetone to clean the appliances.
Razor Head Assembly: After Each Use
◗ It is recommended that you clean the Razor
Head Assembly thoroughly after each use to
maintain optimal shaving performance.
1 Press the on/off button to turn razor oN.
C
2 Rinse Razor Head Assembly under hot
tap water by letting the water run in and
around all the openings for at least 30
seconds.
C
3 You can also immerse the Razor Head
Assembly in hot water for at least 30
seconds.
Make sure the razor is ON to thoroughly remove
any residue.
BE CAREFUL TO TEST WATER FIRST SO AS NOT
TO BURN OR SCALD HANDS.
4 Turn razor oFF and shake off excess
water.
18 ENGLISH
5 You can store the razor in the charging
stand.
6 Put the Protective Razor Head Cap on
razor to protect heads.
Note: If lotion build-up has occurred, remove
Razor Head Assembly and soak for a few minutes
under hot water or a degreasing liquid (e.g.
alcohol). Be sure to thoroughly rinse Razor Head
Assembly under tap water before using razor.
Razor Head Assembly: Once A Month
Do not mix up the cutters and combs as the
shaving performance may be adversely affected
for several weeks before optimal shaving
performance is restored.
1 Turn razor oFF.
C
2 Remove Razor Head Assembly from razor
by pulling Razor Head Assembly straight
up from razor.
C
3 Using your thumb and forefinger turn the
razor head clockwise and lift the comb off
of Razor Head Assembly.
4 Remove and clean one set of cutters and
combs at a time.
19
6
0
1