Philips SCF260-11 - Manual (Page 7)

310
285
255
230
200
170
140
115
85
55
30 ml
fl
.o
z
11
10
9
8
7
6
5
4
3
2
1
310
285
255
230
200
170
140
115
85
55
30 ml
fl
.o
z
11
10
9
8
7
6
5
4
3
2
1
310
285
255
230
200
170
140
115
85
55
30 ml
fl
.o
z
11
10
9
8
7
6
5
4
3
2
1
310
285
255
230
200
170
14
0 115
85
55
30
ml
fl.o
z
11
10
9
8
7
6
5
4
3
2
1
31 0 28 5 25 5 23 0 200 170 14 0 11 5 85 55 30
m l
fl.o z
11 10 9 8 7 6 5 4 3 2 1
310 285 255 230
11 10 9
8
325 295 265 240 210 180 150 120 90 60
30 fl .o z
11 10 9
8
7
6
5
4
3
2
1
325
295
265
240
210
180
150
120
90
60
30 ml
fl
.o
z
11
10
9
8
7
6
5
4
3
2
1
BEEP
310
285
255
230
200
170
40
15
85
55
30
fl
.o
z
11
10
9
8
7
6
5
4
3
2
1
325
295
265
240
210
180
150
120
90
60
30
fl
.o
z
11
10
9
8
7
6
5
4
3
2
1
310
285
255
230
200
170
1
1
ml
310
285
255
230
200
170
1
1
ml
325 295 265 240 210 180 150 120 90 60 30 fl .o z
11 10 9
8
7
6
5
4
3
2
1
ml
v vi vii viii
7. Completion of warming cycle (vi): When the cycle is complete, the warmer will beep intermittently
for 30 seconds and all the volume display lights will continuously flash for 3 minutes. You can
remove the contents as soon as the warmer begins beeping. After 3 minutes, the warmer will
beep 5 times and will turn off automatically.
Note: Philips AVENT recommends removing and using the contents immediately when the
warming cycle is complete, even before the warmer automatically turns off.
8. Open the lid carefully to avoid any residual steam.
Be careful when opening the lid as steam can escape and cause injury. Use a cloth when removing
the container, as it may be hot (vii). Use the lifter to raise small bottles, VIA Cups or small food
jars. Pull the lifter just above the circular rim. Rest the lifter on the rim where it naturally sits.
Note: Do not remove the lifter from the warmer.
9. Before feeding your baby: Always check feed temperature before feeding
(a) Milk – shake the bottle, nurser or milk storage container and check the temperature of the
milk by sprinkling a few drops on the back of your hand.
(b) Food – stir the food thoroughly and test it yourself with a spoon to ensure it is not too hot.
If food is not warm enough, consult the Troubleshooting Guide.
Note: Please ensure the lid of the container is tightly secured prior to shaking.
10. Unplug the warmer and empty any residual water (viii). Ensure that the plug does not come into
contact with water. If warming an additional bottle or container, continue from step 1. Otherwise,
clean the inside and outside of the warmer with a damp cloth (viii). To remove the lifter for
cleaning purposes ONLY, lift vertically up until it naturally resists. Push the handle away from
you and rotate 90º or until it can naturally be removed, then lift out.
Note: For microbiological and hygienic reasons, once heated, milk and food should not be reheated
again, and should be discarded if not used immediately. Please consult your health professional/
breastfeeding advisor for further guidance about safety recommendations on feeding.
Note: If at any time the warmer is switched on and not running a cycle, it will automatically
turn off after 3 minutes if no selections have been made.