Philips DC290-37 - Manual (Page 14)

14
Repeat alarm
1
When the alarm rings, press
BRIGHTNESS/REP ALM.
» The alarm repeats ringing minutes later.
Tip
• You can press / to adjust the interval to
repeat alarm.
Stop alarm ring
1
When the alarm rings, press the
corresponding ALM 1 or ALM 2.
» The alarm stops but the alarm settings
remain.
View the alarm settings
1
Press ALM 1 or ALM 2.
Set the sleep timer
This unit can switch to standby automatically
after a set period of time.
1
Press SLEEP repeatedly to select a set
period of time (in minutes).
» When the sleep timer is activated, the
display shows , and the volume will
gradually decrease in the last 5 minutes.
To deactivate sleep timer
1
Press SLEEP repeatedly until [OFF] (off)
is displayed.
» When the sleep timer is deactivated,
disappears on the display.
Adjust display brightness
1
Press BRIGHTNESS/REP ALM
repeatedly to select different levels of
display brightness.
6 Other features
Set the alarm timer
You can set two alarms which go off at different
time.
1
Ensure that you have set the clock correctly.
(See “Get started - Set time and date”.)
2
Press and hold ALM 1 or ALM 2 for 2
seconds.
» [AL 1] or [AL 2] begin to blink.
3
Press SOURCE on the top panel to select
an alarm sound source: iPod/iPhone, FM
tuner, or buzzer.
4
Press ALM 1 or ALM 2.
» The hour digits begin to blink.
5
Press / repeatedly to set the hour.
6
Press ALM 1 or ALM 2 to confirm.
» The minute digits begin to blink.
7
Repeat steps 5-6 to set the minute.
8
Repeat steps 5-6 to select whether to
ring alarm the whole week, on weekdays,
or at weekend.
9
Repeat steps 5-6 to set the alarm volume.
Tip
• If you set iPhone/iPod playlist as the sound
source, you must create a playlist in iTunes
called “PHILIPS” and import it to your iPhone/
iPod.
• If no playlist is created in the iPod/iPhone or
there is no song in the playlist, the unit will
wake to songs in the iPod/iPhone.
Activate and deactivate the alarm timer
1
Press ALM 1 or ALM 2 repeatedly to
activate or deactivate the timer.
» If the timer is activated, [ AL 1] or
[ AL2] is displayed.
» If the timer is deactivated, [ AL1] or
[ AL2] disappears.
EN