Philips MC-I200-37 - Manual (Page 17)

15
English
Basic Functions
IMPORTANT!
Before you operate the system, complete
the preparation procedures.
Plug and Play
Plug and Play allows you to store all available
radio stations automatically.
First time setup / power up
1
When you turn on the power supply,
"PRESS PLAY TO INSTALL TUNER
PRESS PLAY TO INSTALL TUNER PRESS PLAY TO INSTALL TUNER PRESS PLAY TO INSTALL TUNER PRESS PLAY TO INSTALL TUNER " is
displayed.
2 Press
2 2 2 2 2 to start installation.
➜ "INSTALLING TUNER INSTALLING TUNER INSTALLING TUNER INSTALLING TUNER INSTALLING TUNER " is displayed, followed
by "AUTO PROGRAM IN PROGRESS... AUTO PROGRAM IN PROGRESS... AUTO PROGRAM IN PROGRESS... AUTO PROGRAM IN PROGRESS... AUTO PROGRAM IN PROGRESS... ".
➜ All available radio stations with sufficient signal
strength will be stored automatically, starting
from FM and followed by AM band.
➜ When all the available radio stations are
stored or the memory for 40 presets is used, the
last preset radio station will be played.
To reinstall Plug and Play
1 In standby mode, press and hold
2 2 2 2 2 until "PRESS
PRESS PRESS PRESS PRESS
PLAY TO INSTALL TUNER PLAY TO INSTALL TUNER PLAY TO INSTALL TUNER PLAY TO INSTALL TUNER PLAY TO INSTALL TUNER " is displayed.
2
Press
2 2 2 2 2 again to start installation.
➜ All previously stored radio stations will be
replaced.
To exit without storing the Plug and Play
● Press Ç.
➜ If you do not complete the Plug and Play
installation, the function will be restarted when
you next turn on the power supply again.
Notes:
– When the power is turned on, the disc tray may
open and close to initialize the system.
– If no stereo frequency is detected during
Plug and Play, "PLEASE CHECK ANTENNA" is
displayed.