Philips 40PFL4707-F7 - Manual (Page 13)

English
13
Note
• Ifyouarenotreceivingasignalfromyourcableservice,contacttheCableprovider.
• Ifyoupress orMENU / EXITduringautoprogram,thissetupofTVchannelswillbe
canceled.
• TheinitialautoprogramfunctioncanbeexecutedforeitherAntennaorCableonly
once.Whenyouchangetheconnection(Antenna/Cable),setAutoprogramagain.
➠ p. 20
• IfthereisnosignalInputfromtheantennaterminalandnooperationforseveral
secondsafteryouTurnOntheunit,helpfulhintsappears.Followtheinstructionslisted
ontheTVscreen.
Initial setup
No channel is registered.
Try Autoprogram again?
Verify that you have a cable connected to the “ANTENNA IN” jack
on the back of the TV, the channel installation process
searches this connection. If you are using a cable or satellite
box, please confirm the input which you have connected to
the box and press “SOURCE” key on the remote control to
select the appropriate source input.
Retry
Later
Select OK Skip
After an initial setup is completed...
• Ifyouwanttoscanthechannelsautomaticallyagain.
Autoprogram ➠ p. 20
• YoucanaddthedesiredcableandAnalogchannels
unmemorizedbyautoprogram.
Add channels ➠ p. 21
• Ifyouwanttochangetoanotherlanguage.
Language ➠ p. 27
• Ifyouwanttochangethelocationsetting.
Location ➠ p. 27
• Ifyouwanttorestorethepicturesetting.
Settings assistant ➠ p. 19