Philips 62PL9774-37B - Manual (Page 2)

Positioning the TV
2
Before connecting accessory devices—VCR, DVD player, or HD
receiver, for example—please keep the following in mind:
• Place the TV on a flat surface. An unlevel surface may adversely
affect picture performance.
• Do not place the TV on shag carpet or any surface that will
block the air inlets at the bottom of the set. Blockage will cause
the TV to overheat and shut down.
• Allow 4 to 6 inches of space behind the TV for ventilation.
• To purchase an optional swivel and/or stand to go with your
Philips Cineos TV, see the electronics dealer where you bought
your TV.
• Test various locations in the room to find the optimal spot to
locate the set for best viewing.
• Do not place the TV in direct sunlight or near a heating appliance.
• Do not expose the TV to rain or moisture.
• To prevent any unsafe situations, do not place objects on top of
the TV.
Mounting the Swivel to the TV
Following are instructions for mounting the optional swivel.
NOTE: Attach the swivel before hooking up the TV.
1 Remove the foam cushion polybag from around your TV
and place it on the floor.
2 NOTE: At least two people are required to perform this task.
Carefully lay the TV back flat on the foam cushion polybag
with the screen up.
3 Use screws to fasten rubber bumpers to the swivel as
shown. Guide the two rubber bumpers on the swivel into
the corresponding holes on the bottom of the TV.
4 Use the supplied screws (4) to fasten the swivel to the TV.
Tighten the screws until hand tight. Do not overtighten.
5 Be sure the swivel is in center position.
6 Place the TV and mounted swivel upright on a level sur-
face, preferably a TV stand. An unlevel surface may
adversely affect picture performance. Once you have posi-
tioned TV on a TV stand or other surface, remove the
wooden 0-Degree Holder by pulling it to the left, then
toward the front of the TV. The swivel will not turn until it
is removed.
2
Optional Swivel
Polybag
Rubber Bumpers
Optional Stand
Swivel in Center Position
Screws
Polybag
Remove and Place on Floor
1
3 4
5 6
Allow 4 to 6 inches
behind the TV for
ventilation.
Place the TV on
a flat surface.
Do not place the TV on a surface that will block
the air filters located underneath the set.
Situate the TV where it will not
be exposed to heat or moisture.
For safety, do not set
objects on top of the TV.
0-Degree Holder
0-Degree Holder