Breville AF6 - Manual (Page 5)

5
PREPARING THE FILTER CARTRIDGE
1. Remove the cartridge from its
wrapping (it is normal for the cartridge
to appear moist during storage - this
is simply condensation).
2. Immerse the cartridge in cold water
and agitate gently to remove any air
bubbles.
3. Remove the lid from the upper water
tank.
4. Insert the filter cartridge into the water
tank as shown below. Push it firmly
into place. When correctly fitted, the
cartridge should remain in place
when the tank is turned upside down.
1. Place the upper tank on a suitable
bowl or jug. Fill with cold tap water
up to the MAX FILL LEVEL mark on
the upper water tank and allow the
water to filter through.
Discard the first two fillings. These
first two fillings are used to flush the
filter cartridge. Place the upper tank
back into the unit.
2. Replace the upper water tank lid.
3. Press and hold the START button on
the BRITA Memo on the lid until all of
the bars on the display appear and
flash twice, see “Using the Memo
function” on page 8.
✎ ✎ ✎ ✎ ✎ NOTE
There is no need to pre-soak this
cartridge before use.
Maximum fill level mark
✎ ✎ ✎ ✎ ✎ NOTE
When it is time to replace the cartridge
after 4 weeks use, simply lift the ring
pull handle on top of the cartridge to
remove. The cartridge may be
disposed of in household waste or
contact the BRITA-Care customer
service for advice on recycling
schemes.