Philips VOIP4332B-37 - Manual (Page 33)

33
US
Flash duration
This option is helpful when using operator services. The default value of Flash time that is preset in your
VOIP 433 should be the best suited for your country network and therefore you should not need to change it.
1. In idle mode, press MENU.
2. Press UP / DOWN to select SETTINGS, and then press OK.
3. Press UP / DOWN to select FLASH. Press OK.
4. Press UP / DOWN to select the desire Flash duration. Press OK.
Pause duration
Your phone comes with 2 factory programmed pause durations.
1. In idle mode, press MENU.
2. Press UP / DOWN to select SETTINGS, and then press OK.
3. Press UP / DOWN to select PAUSE. Press OK.
4. Press UP / DOWN to select PAUSE 1 or PAUSE 2. Press OK.
Area code stripping
This section is applicable to models with Area Code Stripping option only.
Area code stripping removes an area code as specified by you from any incoming caller ID.
To activate and program the area code to be stripped :
1. In idle mode, press MENU.
2. Press UP / DOWN to select SETTINGS, and then press OK.
3. Press UP / DOWN to select AREA CODE. Press OK.
4. Press LEFT / RIGHT to select ON.
5. Press DOWN . Enter area code . Press OK to confirm.
Other features