Philips AVENT Microwave Sterilizer Starter Set SCF271-02 User Manual

Page 3

Loading one VIA Disposable Nurser* and up to
four 6oz/180ml OR 8oz/240ml VIA Cups and Lids

1. Position the nipple in an outer nipple cavity.
2. Place the screw ring over the nipple.
3. Position the VIA Cups upside down around

the dome cap stem.

4. Place the VIA Adaptor on its side around the

racks edge (as shown).

5. Position the VIA Lids vertically around the racks

edge. Rims should face out for easier loading.

6. Place the dome cap in the unobstructed upper

slot of the dome cap stem.

Loading other feeding and baby product items
When sterilizing other NON-ELECTRICAL AVENT PRODUCTS
simply place the components in the rack allowing
enough space so that steam can effectively circulate.

NOTE: Do not overload the sterilizer.
NOTE: Do not place dome caps in the sterilizer upside down.
NOTE: The AVENT Express II Microwave Steam Sterilizer is
designed to specifically hold the wide shape of AVENT Natural
Feeding Bottles.

* Consists of VIA Cup, Lid and Adaptor, an Extra Soft Slow Flow

Nipple, Dome Cap and Screw Ring

After each cycle

IMPORTANT: Allow the unit to cool for at least two minutes
before removing the sterilizer from the microwave.
1. Removing the sterilizer from the microwave: After

the unit has cooled, remove it from the microwave
by holding the skirt and/or safety grips and then
place on an even, heat-resistant surface.

NOTE: Items will remain sterile in the AVENT Express II Microwave
Steam Sterilizer for up to 24 hours providing the lid is not removed.

2. After removing the sterilizer from the microwave:

Remove the lid by unlocking the clips – When removing
the lid, point it away from you to allow steam to escape.

Care and cleaning
• Always drain the excess water from the unit and

rinse to prevent the build up of limescale.

• Always store when completely dry.
• The AVENT Express II Microwave Steam Sterilizer

is dishwasher safe.

WARNINGS –
FAILURE TO FOLLOW INSTRUCTIONS MAY
CAUSE SCALDING OR DAMAGE TO THIS
PRODUCT AND/OR YOUR MICROWAVE

• Always ensure you use 200ml of water

before sterilizing. (The unit should be
emptied of residual water before each
subsequent use.)

• Always follow loading instructions and

do not overload.

• Do not use bleach or chemical sterilizing

solutions/tablets in sterilizer or on
products to be sterilized.

• Do not sterilize metallic or electronic items

in the sterilizer.

• Do not microwave bottle brush.

• Always use the appropriate heating time

for the power of your microwave unit.
(see Table )

• In combination ovens, ensure grill is

switched off and has cooled before use.

• Be sure that the lid is properly fastened to

the base before placing in microwave.

• Always allow at least 2 minutes cooling

time before removing from the microwave.

• Do not remove the lid from the sterilizer

immediately after cycle. Allow to cool as
the steam will be hot.

• When removing from microwave, be sure

to hold the sterilizer level to avoid leaking
or spilling of hot water.

• When taking the sterilizer out of the

microwave, BE CAREFUL – it will still be hot.

• When removing the lid, point it away from

you to allow steam to escape.

• Be careful when handling the sterilized

products as they may be hot.

• Always keep out of reach of children.

Some products featured may not be available in all
countries. Please contact AVENT to check availability.

AVENT® is here to help
1.800.54.AVENT
www.aventamerica.com

III