Philips VRX463AT - Manual (Page 36)

POWER
CBL/DSS VCR TV
EJECT
MUTE
MENU
JOG/SHUTTLE
EXIT/STATUS CLEAR
VCR PLUS+/ENTER
F.ADV
PAUSE/STILL
1 2 3
4 5 6
7 8 9
100 0 GO-TO
MEMO INDEX
VAR.
SLOW
REMOTE LOCATOR
SKIP VCR/TV SPEED
SEARCH
SLOW TRACKING
STOP
REW FF
PLAY
VOL
CHANNEL
/OTR REC
ONE TIME PROGRAM
PROGRAM 1
CHANNEL 10 CABLE/TV
TIME ON 09:30 PM
TIME OFF 11:00 PM
REC SPEED SLP
START DATE 07/10/97
THU.
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
36 Timer Recording (cont’d)
ONE TIME PROGRAM
PROGRAM 1
CHANNEL 10 CABLE/TV
TIME ON 09:30 PM
TIME OFF 11:00 PM
REC SPEED SLP
SP=1 SLP=2
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
8
Press the Number 1 button to record in SP speed. Press
the Number 2 button to record in SLP speed. You cannot
use the (Tape) SPEED button at this time.
11
Press the POWER button to turn off the VCR. The TIMER
light will appear on the display panel. (The TIMER light and the
Cassette-Inside light will flash if there is not a tape in the VCR.)
The VCR must be turned off for a timer recording to take
place. If you forget to turn off the VCR, PLEASE TURN OFF
VCR FOR TIMER RECORDING flashes on your TV screen two
minutes before a timer recording starts. To remove the message,
press the CLEAR button.
Tape Speed Maximum Record/Playback Time
T160 T120 T60
SP 2 hrs.
2 hrs. 1 hr.
(Standard Play) 40 mins.
LP 5 hrs.
4 hrs. 2 hrs.
(Long Play) 20 mins.
SLP
8 hrs. 6 hrs. 3 hrs.
(Super Long Play)
Tape Speeds
This chart shows the recording/playback time
for T160, T120, and T60 video cassettes.
There are three playback speeds: SP, LP, and
SLP. This VCR will play tapes recorded in LP,
but LP will not appear on the display panel.
This VCR will only record in SP and SLP.
9
Press two Number buttons for the month and two
Number buttons for the day you want the program to
record. For example, for July 10, press 07, 10. The day of the
week and the year will appear automatically. (You cannot program
the VCR to record more than one year in advance.)
10
Press the EXIT/STATUS button. PROGRAM WAS COM-
PLETED/PLEASE TURN OFF VCR FOR TIMER RECORDING will
appear on-screen. In three seconds, the message will disappear.
(If PROGRAM NOT COMPLETED appears, try again from step 1.
If PROGRAM NOT COMPLETED/CLASH appears, the timer
recording you just programmed overlaps with an earlier timer
recording. The timer recording you just programmed will not take
place.)
The VCR must be
off for a timer
recording to occur.
Make sure the VCR
has a tape.
8
9
10
11