Philips VRX463AT - Manual (Page 29)

POWER
CBL/DSS VCR TV
EJECT
MUTE
MENU
JOG/SHUTTLE
EXIT/STATUS CLEAR
VCR PLUS+/ENTER
F.ADV
PAUSE/STILL
1 2 3
4 5 6
7 8 9
100 0 GO-TO
MEMO INDEX
VAR.
SLOW
REMOTE LOCATOR
SKIP VCR/TV SPEED
SEARCH
SLOW TRACKING
STOP
REW FF
PLAY
VOL
CHANNEL
/OTR REC
Remote Locator 29
SET LOCATOR CODE
REMOTE LOCATOR CODE IS 4
TO SELECT PUSH 0-9
SET LOCATOR CODE
REMOTE LOCATOR CODE
HAS BEEN CHANGED
NEW CODE IS 6
TO CHANGE CODE,
PUSH MUTE AND PAUSE KEY
FOR 3 SECONDS.
TO END PUSH EXIT
• The VCR may not find the remote
control if the remote is placed on a
metal shelf or on counter material.
• Any changes or modifications to the
remote control not expressly
approved by Philips Consumer
Electronics Company could void the
user’s authority to operate the
remote control.
• If you change the remote locator
code in the steps above, you must
reprogram the remote control when
you replace the batteries.
Helpful Hints
4
Press one Number button (0 - 9) on the remote control
to set a new locator code. (If you press any other button, the
code won’t be set.) The remote control will beep briefly, indicat-
ing that the locator code has been changed successfully. The new
code will appear in the menu, then the menu will disappear.
When you use the Remote Locator feature, your VCR can find
your remote control. To find your remote, follow these steps.
1
Press the POWER button on the VCR to turn on the VCR.
LOCATING REMOTE appears on the TV screen briefly. Within a
few seconds, the remote control will start beeping. It will beep for
about 30 seconds.
2
When you find the remote control, point the remote at the
VCR’s remote sensor and press any button on the remote
control to stop the beeping.
The VCR may find other remote controls in your home, or even in an
apartment complex. To program the VCR to find its remote control only,
follow these steps.
1
Press the VCR button, then press the MENU button.
2
Press the Number 6 button to select SET REMOTE LOCA-
TOR.
3
Press and hold the MUTE button and the PAUSE/STILL
button at the same time for three seconds. The current
remote locator code will appear on-screen.
To program the VCR to find its
remote control only....
1
2
3
4