Briggs & Stratton Harrier 41 - Manual (Page 19)

1.19
To prevent accidents stop the engine disconnect the spark plug
lead before attempting to carry out maintenance procedures on
the mower.
1. Air Filter
2. Fuel Cap
3. Start Grip
4. Oil Cap/ Dipstick
5. Exhaust Guard
6. Spark Plug / Lead
Loosen casing clamp screw (1) and move the governor lever (2) in the
direction of screw (1) as far as posible. Move the throttle control to
the choke position. Tighten casing clamp screw.
Should only be made by an authorised Briggs & Stratton dealer. Under
no circumstances should the engine be adjusted to run at a speed in
excess of that shown on the Declaration of Conformity.
MOWER
1
2
3
BRIG GS & ST RATT ON
HARRIER 41
6 5
4
2
1
Engine
Throttle Cable Adjustment
Carburettor Adjustments
MAINTENANCE