Philips VRX562AT - Manual (Page 53)

Before
Tracking
Adjustment After
Tracking
Adjustment
Automatic Operation Features (cont’d) 53
Automatic Tracking Adjustment
The VCR continually adjusts tracking automatically to give you the
best possible picture quality. With some recordings, however, you
may get a better picture using the manual tracking controls (see
below).
Manual Tracking
To adjust the tracking manually, press the TRACKING (Up/Down)
buttons on the remote control.
NOTES:
• The CHANNEL (Up/Down) buttons on the VCR adjust tracking dur-
ing playback. This function is controlled only by the CHANNEL
(Up/Down) buttons on the VCR. The CH(annel) Up/Down buttons
on the remote control will not adjust tracking.
• To return tracking to the position it was in when the VCR was
shipped from the factory, press the CHANNEL (Up) and CHANNEL
(Down) buttons on the VCR at the same time.
• Tracking is returned to auto tracking when a tape is inserted, or
when the STOP button is pressed to halt playback.
• When the VCR is in Slow mode, auto tracking will not work. Instead,
use the TRACKING (Up/Down) buttons on the remote control or
the CHANNEL Up/Down buttons on the VCR to reduce noise lines
in slow motion playback.
• Manual tracking will not operate when the VCR is in Still mode. If
you want to reduce noise lines in a still picture, place the VCR in Slow
mode. Use the TRACKING (Up/Down) buttons on the remote con-
trol or the CHANNEL Up/Down buttons on the VCR to remove the
noise lines. Then return to Still mode.