Behringer AT108 - Manual (Page 5)

5
ULTRACOUSTIC AT108
2. WIRING TIPS
+
If the unit is damaged, please do NOT return it to
BEHRINGER. Instead, notify your dealer and the
shipping company immediately. Otherwise, claims
for damage or replacement may not be honored.
+
Always use the original packing carton to prevent
damage during storage or transport.
+
Make sure that no children are left unsupervised
with the AT108 or its packaging.
+
Please ensure proper disposal of all packing
materials.
1.1.2 Initial operation
Be sure that there is enough space around the unit for cooling.
To avoid overheating, please do not place the ULTRACOUSTIC
near radiators and other equipment emanating heat.
+
Please keep in mind that all the equipment has to
be grounded at all times. For your own protection,
never change or disable the grounding on your
equipment or on the cables! The unit shall always
be connected to the mains socket outlet with a
protective earthing connection.
1.1.3 Online registration
Please do remember to register your new BEHRINGER
equipment right after your purchase by visiting
www.behringer.com (alternatively www.behringer.de) and
kindly read the terms and conditions of our warranty carefully.
Should your BEHRINGER product malfunction, our goal is to
have it repaired as quickly as possible. To arrange for warranty
service, please contact the retailer from whom the equipment
was purchased. Should your BEHRINGER dealer not be located
in your vicinity, you may directly contact one of our subsidiaries.
Corresponding contact information is included in the original
equipment packaging (Global Contact Information/European
Contact Information). Should your country not be listed, please
contact the distributor nearest you. A list of distributors can be
found in the support area of our website (www.behringer.com/
support).
Registering your purchase and equipment with us helps us
process your repair claims quicker and more efficiently.
Thank you for your cooperation!
2. WIRING TIPS
Fig. 2.1 and 2.2 show you how to connect your guitar and
your microphone to the amplifier.
If you want to use an effects pedal (for example, the
BEHRINGER X V-AMP) to experiment with some out-of-the-
ordinary sounds, you can connect your guitar directly to the
input of the effects processor. Then, connect a second cable
from the effects output to the input on your amp.
If you have an electronic tuner, please be sure to insert it pre
effects device, so that the tuner only receives a dry signal without
effects components.
X V-AMP: no additional tuner required.
+
The built-in loudspeaker is disabled automatically
when you plug in the headphones .
Fig. 2.1: Setup example using the ULTRACOUSTIC AT108
Fig. 2.2 shows a recommended setup for amplifying the sound
of your AT108 using a sound reinforcement system of any size.
This way, you can also use your amp for playing live or for
rehearsals with your band.
Fig. 2.2: Live setup