Philips SB2000B-37 - Manual (Page 10)

10 EN
7 Product
information
Note
• Product information is subject to change without prior
notice.
General information
Power Supply (through
USB socket)
5 V 1 A
Built-in Battery Lithium battery
(500 mAh, 7.4 V)
Dimensions - Main
Unit (W x H x D)
123 X 92 X 123 mm
Weight - Main Unit 0.6 kg
Bluetooth
Bluetooth
specification
V3.0
Supported profiles A2DP v1.0, AVRCP
V1.0, HFP, and HSP
Range 10 m (Free space)
Amplifier
Rated Output Power 5 W RMS
Signal to Noise Ratio > 50 dBA
Audio input through
micro USB socket
650 mV RMS,
22 kOhm
8 Troubleshooting
Warning
• Never remove the casing of this product.
To keep the warranty valid, never try to repair
the product yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page
(www.philips.com/support). When you contact
the Consumer Care, make sure that the
product is nearby and the model number and
serial number are available.
General
No power
• Recharge your speaker.
No sound
• Adjust volume on this product.
• Adjust volume on the connected device.
• Make sure that your Bluetooth device is
within the effective operational range.
No response from the speaker
• Restart the speaker.
About Bluetooth device
The audio quality is poor after connection
with a Bluetooth-enabled device.
• The Bluetooth reception is poor. Move the
device closer to this product or remove
any obstacle between them.
Cannot connect with the device.
• The Bluetooth function of the device is not
enabled. Refer to the user manual of the
device for how to enable the function.
• This product is already connected with
another Bluetooth-enabled device.
Disconnect that device and then try again.