Philips RI9833-47 - Manual (Page 9)

• 9 •
English
Steady on
Steady on
Steady on
Using the machine for the
first time or after a long
period of inactivity.
These simple operations will make it pos-
sible to always brew excellent coff ee.
1 Place a large container under the
dispensing spout.
2 Before starting the procedure, check
that the following icon is displayed and
that the buttons “
” and “ ” on
the control panel are steady on.
3 Select the pre-ground coff ee function
by pressing the “ “ button one or
more times.
Do not add the pre-ground
coff ee to the compartment.
The icon will appear on the display.
4 Press the button to brew a long cof-
fee.
5 Wait until brewing is completed and
empty the container.
6 Repeat the operations from step 1 to
step 5 for 3 times; then continue with
step 7.
7 Place a container under the steam wand
(Pannarello, if supplied).
8 Turn the selector switch clockwise to set
it to the “ ” position.
9 Dispense water until the no water si-
gnal is displayed, then turn the selec-
tor switch counter-clockwise to set it
to the “ ” position.
10 At the end, fill the water tank again.
Then the products can be brewed as
described in the following sections.
Rinse/Self-cleaning Cycle
This cycle allow rinsing the coff ee circuits
with fresh water.
The cycle is carried out:
• At machine start (with cold boiler)
• After priming the water circuit (with
cold boiler)
• During the Stand-by preparation phase
(if a coff ee product has been brewed)
• During the phase of activating the
stand-by mode after pressing the
“STAND-BY” button (if a coff ee product
has been brewed).
A small amount of water will be dispen-
sed, which will rinse and heat all the ma-
chine components; in this phase the but-
tons “
” and “ ” blink alternately.
Wait for the cycle to fi nish automatically.
You can stop dispensing by pressing
either of the two brew buttons.
Blinking