Brinkmann ProSeries 4435 User Manual

Page 26

Text mode
Original mode

NOTE: With the help of a friend, turn

the cart to its upright position.

Step 4

Place tank tray assembly over vent
holes in bottom cart panel and
secure using four M6 X 15mm
bolts. Tank tray should slide in and
out of cart freely.

Step 5

Install door bracket using four
M6 X 50mm bolts. Make sure the
door stop is set toward back of cart.
(Hand tighten only at this point.)

Step 6

Attach the grease cup bracket onto
the back panel by inserting the
three tabs into the slots on the back
cart panel.

Cylinder Clamp

Center Cut-out

Tank Tray Assembly