Philips SWW1800-27 - Manual (Page 13)

13
Mode Power LED
indicator
Standby (Listen mode) Solid purple
Standby (Sleep mode) Solid red
Startup or RF connection
interrupted
Flashing blue
On with unrecognized video
format
Solid blue
On with recognized video
format
Solid blue
Fail to find the video source
device
Solid blue
Mode Source LED
indicator
Standby Off
Startup or RF connection
interrupted
Flashing
On with unrecognized
video format
Flashing slowly
(once per
second)
On with recognized video
format
Solid blue
Fail to find the video
source device
Flashing quickly
(3 times per
second)
Mode On screen display
(If TV supports
CEC)
Startup LINK START &
LINK VERIFY
On with recognized
video format
NoModeSupport
Fail to find the video
device
NO SIGNAL
Select the source on the transmitter
Press the source buttons: 1 HDMI , 2 HDMI,
3 INPUT, 4 INPUT on the remote control or
transmitter until you see the available video
from your device.
Note
In standby mode, a red power LED displays on •
the transmitter.
Depending on equipment and the input •
selected, between input selection/start-up and
being able to see the image on your TV can
take up to 15 seconds.
Establish the link between the
transmitter and receiver
A flashing blue power LED displays until
the signal like between the two units are
established. Normally, it takes around 15-20
seconds for the link to establish successfully.
LED indicator status of the
transmitter
Check the LED indicator status to ensure the
link between the transmitter and receiver is
established.
English
EN