Philips 40PFL4709-F7 - Manual (Page 18)

Watching Channels from an External Device
Switching Each Input Mode can easily switch with the Remote Control
between TV (DTV or Analog TV) and External Devices when they are
connected to the Unit.
1
Turn On a Set-top Box or the Connected Device.
●
The picture from the Set-top Box or the Connected Device might
appear Automatically on the TV screen.
If the picture does not appear
① Press S SOURCE Repeatedly to select the Set-top Box or the
Connected Device and wait a few seconds till the Picture appears.
● Pressing H reverses the direction of the Input modes.
11.1
PC
Video
Component
HDMI2 HDMI1
PC
Video
HDMI2
HDMI1
TV
Source
or
DTV / Analog TV
channel
e.g.)
HDMI3
HDMI3
② Use the Remote Control for the Set-top Box or the Connected
Device to select Channels to view.
Sleep Timer
Sleep Timer can set the Unit to go into Standby mode after an incremental
period of time.
Press SLEEP Repeatedly to change the amount of time
(increases the time by 30 minutes up to 120 minutes).
Press SLEEP Once to call up the display for checking the remaining time.
●
To cancel Sleep Timer, press SLEEP Repeatedly until Off is displayed.
120min. Sleep timer
Switching Audio Mode
Digital TV Operation
1
Press SAP to display the currently selected Language
and the number of available Languages.
2
Press SAP Repeatedly to cycle through the available
Audio Languages.
11.1
1/3 English
Note(s)
● Available Languages differ depending on the Broadcast.
● Other is displayed when the Audio Language cannot be acquired or the acquired
Languages are other than English, French or Spanish.
Cable / NTSC (Analog) TV Operation
1
Press SAP to display the currently selected Audio mode.
2
While receiving an MTS broadcast, press SAP Repeatedly
to cycle through the available Audio Channels.
e.g.) When All Audio Modes are available
SAP / STEREO SAP / MONO SAP / STEREO
11
SAP / STEREO
STEREO : Outputs Stereo Audio
SAP : Outputs a Second Audio Program
MONO : Outputs Mono Audio
18 .
English