Philips DVP1013-F7E - Manual (Page 13)

E
ng
li
sh
13
AUDIO IN
R L VIDEO
IN
TO TV ANT IN
CH3 CH4
ANT IN
ANT IN
1
3 4
2
TIPS: Before making or changing any connections, make sure that all the devices are disconnected
from the power outlet.
Connections
(continued)
IMPORTANT!
– If your television only has a single
Antenna In jack (or labeled as 75
ohm or RF In,) you will need an RF
modulator in order to view the
DVD playback on the television. See
your electronics retailer or contact
Philips for details on RF modulator
availability and operations.
Using an accessory RF modulator
A Use the composite video cable (yellow)
to connect the DVD player’s CVBS jack
to the video input jack on the RF
modulator.
B Use the RF coaxial cable (not supplied) to
connect ANTENNA OUT or TO TV jack
on the RF modulator to the ANTENNA
IN jack on the television.
RF coaxial cable to TV
Back of RF Modulator
(example only)
C To hear sound of this DVD player
through your TV, use the audio cables
(white/red) to connect AUDIO OUT (L/
R) jacks of the DVD player to the
corresponding AUDIO IN jacks on the
RF modulator (cable supplied).
D Connect the Antenna or Cable TV
service signal to the ANTENNA IN or RF
IN jack on the RF modulator. (It may
have been connected to your TV
previously. Disconnect it from the TV).
01-41_dvp1013_F7_eng.indd 13 01-41_dvp1013_F7_eng.indd 13 12/16/2008 1:41:04 PM 12/16/2008 1:41:04 PM