Bush Hog RFM 60 User Manual

Page 11

G. Clamp end of driveline in a vice. Cut off shield

where marked. (Figure 2-3).

Figure 2-3

H. Using cut off section of shield as a guide, cut

shaft the same amount. (Figure 2-4)

I. Repeat steps “G” and “H” to other driveline sec-

tion.

J. Deburr ends of driveline sections and clean

away all chips and filings. (Figure 2-5)

K. Apply multi-purpose grease to outside of male

driveline section. Assemble driveline and install on
tractor and cutter. Pull on each driveline section to
be sure yokes lock into place. Make certain driveline
shielding is in place and in good condition.

Figure 2-4

Figure 2-5

MAKE CERTAIN DRIVELINE YOKES
ARE SECURELY FASTENED. FAILURE
TO DO SO MAY RESULT IN SERIOUS
INJURY.

L. Raise cutter off ground and adjust lower lift

arms to level cutter right to left. Refer to tractor oper-
ator’s manual.

M. Lower cutter to work position. Adjust tractor

top link to position cutter top flex link as shown in
Figure 2-6. This allows cutter to “float” during opera-
tion.

N. Adjust tractor sway chains, stabilizer bar or

equivalent to prevent side sway.

DANGER

Tractor