Philips AJ3936-17 - Manual (Page 9)

INSTALLATION AND GENERAL FEATURES
9
1. Check if the power voltage, shown on the type plate on the
bottom of the set, corresponds to your local power supply. If
it does not, consult your dealer or service center.
2. Connect the power plug into the wall outlet. The power
supply is now switched on and the numbers on the display
will start to flash. You will need to set the correct time.
3. To disconnect the set completely from the power supply,
remove the power plug from the wall outlet.
Standby power consumption (clock mode): 3W.
Self-Powered Back-up
The self-powered back-up conveniently allows your day, alarm
and clock time settings to be stored for up to 3 minutes when
there is a power interruption e.g. AC power failure.
The complete CD clock radio and illumination will be switched
off. As soon as the power supply returns, the display will indicate
the correct time.
• If power supply resumes after 3 minutes, the numbers on the
display will start to flash and you will need to re-enter the
day, time and alarm settings.
lllumination brightness
1. Check if the clock control is adjusted to CLOCK position.
2. Press REPEAT ALARM/
BRIGHTNESS CONTROL once or more.
– The brightness of the display will change in this sequence:
LOW y MEDIUM y BRIGHT y LOW...
Note:
During an alarm call or when slumber is active the brightness
cannot be adjusted.
Display
• The flashing display reminds you whether you have set the
clock/ alarm time properly. The time flashes continuously
after setting the clock/ alarm time until you adjust the clock
control to the final CLOCK position.
• When you adjust VOLUME
4 or 3 the display shows the
volume level briefly, e.g. uo:09.
POWER SUPPLY
AJ 3935 /17 page 9
English
CD
XP AJ 3936/17 19-09-2000 12:13 Pagina 9