Philips AJ3936-17 - Manual (Page 14)

RADIO RECEPTION
14
1. Press RADIO•BAND to switch on the radio mode.
–
and the last waveband selected appears in the display.
2. Press RADIO•BAND again if you wish to select another
waveband.
3. Turn the TUNING wheel to find your station.
To improve reception:
FM: uses a built-in antenna in the power cord. Adjust the
position of the power cord slightly for optimum reception.
AM: uses a built-in antenna. Direct the antenna by adjusting the
position of your set.
4. Adjust the sound with VOLUME 4 or 3.
5. Press 9 STOP•OFF to switch off the radio.
– disappears from the display.
Note:
If you want to listen to the radio during a buzzer melody or CD
mode alarm call/ repeat alarm, you must first stop the alarm by
pressing either one of the following:
–
9 STOP•OFF;
– ALARM 1 or 2 MODE OFF;
– 24-HOUR ALARM RESET.
General
Two different alarm times, ALARM 1 or 2 can be set in a variety
of modes. This can be useful when for example you need to wake
up at a different time during the week and at the weekend.
Setting ALARM 1 or ALARM 2 time
1. Adjust the clock control to SET ALARM 1 or 2 ALARM
TIME.
2. Press UP
7 or DOWN8 to adjust both the hours and minutes:
– with your finger held down on UP 7 or DOWN8 respectively,
the time will increase/ decrease rapidly and continuously
from minutes to hours.
– Press UP 7 or DOWN8 briefly and repeatedly to adjust the
time slowly, minute by minute.
3. Release UP 7 or DOWN8 when you have reached the correct
alarm time setting.
4. Adjust the clock control back to CLOCK.
5. Select your choice of alarm mode by pressing ALARM 1 or 2
MODE•OFF once or more until the display shows your choice
of alarm: buzzer
, radio or CD next to ALARM 1 or
ALARM 2.
SETTING THE ALARM TIME
RADIO
RADIO
English
AJ 3935 /17 page 14
g e n t l e w a k e
BRIG
H TN ESS C ON TROL
R EPEA
T ALA
R M
XP AJ 3936/17 19-09-2000 12:13 Pagina 14