Philips 2000 series LED-LCD TV 39PFL2908 39" class-po - Manual (Page 18)

18 English
Initial setup
This section will guide you through the unit’s initial setting which includes
selecting a language for your on-screen menu, country, location and
AutoProgram, which automatically scans and memorizes viewable
channels. You can also set the network connection in this setting.
Before you begin:
Make sure the unit is connected to antenna or cable.
1
After making all the necessary connections, press to Turn On the
unit.
• It may take a few moments to Turn On the unit for the first time.
• Initial setup menu appears automatically after the unit is Turned
On.
2
Use ▲▼ to select the on-screen language, country, TV placement,
location on the right side of the TV screen, then press OK.
• You must set Home in location setting. Otherwise, Picture and
Sound settings you adjusted will not be memorized after the unit
goes into Standby mode.
3
Use ▲▼ to select the signal type.
• If the TV is connected to a cable box or satellite set-top box,
select the 2nd one and skip to step 5.
4
Use ▲▼ to select Antenna for TV channels or Cable for CATV
channels, then press OK.
– When Antenna is selected, the TV detects antenna signals. It
searches for DTV and Analog TV channels available in your area.
– When Cable is selected, the TV detects signals supplied by cable. It
searches for DTV, Analog TV and Cable channels available in your
area.
• Autoprogram will begin.
5
After the channel installation is completed, Network setup screen
will appear. Use ▲▼ to select Wireless or Wired, then press OK.
• If you have a router with WPS function, select Wireless and use
▲▼ to select Easy Connect, then press OK.
6
Follow the on-screen instructions to complete the installation.
• When you select On in the selection screen of Auto software
update. A message will appear if there is the latest software on
the network server.
7
Use ◄► to select Start, then press OK to begin Settings assistant.
8
Press ◄ or ► 5 times to select the side of the pictures that is the
most pleasing to you, then press OK.
Continued on next page.
These operations are accessible by remote control.
Some may also be accessible by control panel on the main unit.
To set up a TV signal from a cable TV
wall jack or a standard TV antenna.
Select
To set up a TV signal from a cable TV
box or satellite TV receiver.
Select
Antenna
Cable
Skip
Make sure that you have
attached your antenna or cable
signal into the jack on the back
of your TV labeled "ANTENNA IN".
Now select either Antenna or
Cable, using up/down key of the
remote control. Once you
have
made your selection, press the
OK button to proceed.
Wireless
If you have a Wireless router, select Wireless to connect
to the Internet.
Wired
If you connect with an Ethernet cable, select Wired to
connect to the Internet.
System searching. Please wait...
Digital channels found: 0
Analog channels found: 0
Auto programming may take more than 20 minutes to
complete. Digital channels will take longer than Analog
to find and program. Please wait until you see
the Auto Programming complete message.
Stop
This TV can be connected to
your home network.
Select your connection type.
Wireless
Wired
Skip
Cancel Start
Settings assistant will allow you to customize your picture settings to your personal
preference. You will see a series of test pictures where the right side and left side
differ. Select the side that is most pleasing to you with the Left/ Right buttons.
The energy consumption in the “Standard” setting is Energy Star certified.
Which side of the picture do you prefer?
Cancel Picture A Picture B