Philips 40PFL7705D-F7 - Manual (Page 38)

37 EN
English
Network update
You can update the software by connecting the unit to the internet.
1
Follow steps 1 to 2 in ‘Connection test’ on page 30.
2
Press MENU on the remote control and then use О/п/Н/Ж to
select [Setup] > [Software Update] > [Updates] > [Network] kk .
3
Use Н/Ж to select [Yes], then press OK.
• This unit will then start checking for the latest fi rmware
version.
4
Confi rmation message will appear. Use Н/Ж to select [Yes], then
press OK.
•
The unit will start downloading the latest fi rmware version.
• The unit will start updating the fi rmware version.
• It may take a while to complete the updating.
5
When the software update is complete, press POWER . at the
side of the TV to make sure the unit goes to standby mode.
6
Switch on the TV.
»
The TV starts up with the new software.
Note
• In order to update software via the internet, you must connect the unit to the internet
and set up necessary settings.
• For the network connection, refer to ‘Connecting the TV to the internet using an
Ethernet cable’ or ‘Connecting the TV to the internet using a USB wireless LAN
adapter’ on page 41.
• For the network setup, refer to ‘Network’ on page 30.
• Please do not unplug the AC power cord or Ethernet cable while executing the
‘Network update’.
• All settings will remain the same even if you update the software version.
• The version of Netfl ix will also be updated if newer version of Netfl ix is available when
updating the fi rmware.