Philips DC199B-37 - Manual (Page 17)

English
17
Radio Reception
Tuning to radio stations
1
Press TUNER to select the tuner source.
2
Hold S / T and then release the button.
➜ The system will start searching for a radio
station with sufficient signal strength.
3
Repeat step 2 if necessary until you find the
desired station.
● To tune to a weak station, press S / T briefly
and repeatedly.
Programming radio stations
You can store up to a total of 20 radio stations
in the memory.
Automatic programming
Automatic programming will start at preset
number 1 and all your former presets will be
overridden.
● Press PROG/ CLOCK for more than 3
seconds to activate programming.
➜ All available stations are programmed.
Manual programming
1
Tune to your desired station (refer to “Tuning to
radio stations”).
2
Press PROG/CLOCK to activate
programming.
➜ PROG flashes in the display.
3
Press ALBUM/PRESET 3 4 to allocate a
number from 1 to 20 to this station.
4
Press PROG/CLOCK again to confirm the
setting.
➜ PROG disappears, the preset number and
the frequency of the preset station are shown.
5
Repeat the above four steps to store other
stations.
● You can override a preset station by storing
another frequency in its place.
Tuning to preset radio stations
● Press ALBUM/PRESET 3 / 4 until the
desired preset station is displayed.
pg001-025_DC199_37-Eng 2007.11.22, 15:52 17