Philips 3000 series LED-LCD TV 32PFL3509 32" class-po - Manual (Page 17)

4 Use your TV
Switching on your TV and putting it in Standby
mode
Remote Control
TV
To Turn the TV On from Standby or Off to Standby
● Press B on the Side or Front panel or the Remote Control.
Note(s)
● Energy Consumption contributes to air and water pollution. When the AC Power Cord
is plugged in, your TV consumes energy with a very low standby Power Consumption.
Adjusting Volume
Remote Control
TV
To decrease or increase Volume
● Press VOL J / K on the Front panel or press VOL + / – on the Remote
Control or the Side panel.
VOL J(-) : Volume Down
VOL K(+) : Volume Up
To mute or unmute sound
● Press V on the Remote Control to mute the sound.
● Press V again or VOL + / – to recover the original sound.
Switching Channels
TV
Remote Control
To select Channels by using CHI / H or CH + / –
● Press CH I (Down) / H (Up) on the Front panel or press CH + / –
on the Remote Control or the Side panel.
To select Channels by using the NUMBER keys
Digital TV Operation
●
For Digital channels, press a number followed by a dot “•” and the
corresponding sub channel number.
–
When selecting Digital channel 11.1
Be sure to press • before entering the subchannel number.
Cable / NTSC (Analog) TV Operation
– When selecting Cable or Analog channel 11
Press PREV.CH to return to the previously viewed channel.
Note(s)
● To select the non-memorized channels, use the NUMBER keys.
● No signal will appear on the TV screen after the subchannel broadcast is over.
● Audio only program message will appear on the TV screen, when you receive only a
sound signal.
17 .
English