Philips 50PF7220A-37 - Manual (Page 38)

36
& Press the AV+ button repeatedly or select Source in the Settings menu
(see p. 16) to select AV1 , AV2 , AV3 , HDMI1 , HDMI2 , Side or TV , according
to where you connected your devices.
é Press the cursor up/down.
“ Press OK .
.@
7 8 9
0 AV+ -
✓ - FAVORITES -
FORMAT RECORD
VIEW
A/CH INFO
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one
or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio or television technician
for help. Modifications -
The FCC requires the user to be notified that any changes or
modifications made to this device that are not expressly approved by
Philips Consumer Electronics may void the user’s authority to operate
the equipment.
Cables -
Connections to this device must be made with shielded cables with
metallic RFI/EMI connector hoods to maintain compliance with FCC
Rules and Regulations.
Canadian notice -
This Class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
Avis Canadien -
Cet appareil numérique de la classe B respecte toutes les exigences
du Règlement sur le matériel brouilleur du Canada.
Regulatory Notices - Federal Communications Commission Notice
To select connected devices
Record a TV program
You can record a TV program using your recorders tuner without affecting your TV.
& Select the channel number on your recorder.
é Set your recorder to record.
See the handbook for your recorder.
Switching channel numbers on your TV does not disturb recording !
Record a program from monitor out
You can record a program on your recorder from the TV tuner via MONITOR OUT .
& Select the correct channel on your TV and the correct input on your recorder.
é Set your recorder to record.
Do not switch channels or turn off your TV when you are recording through MONITOR OUT .
Notes:
- When a TV channel or AV source is blocked because of a rating set via the Channels menu (see p. 24), also the record output picture and
sound are muted.
- In case of an analog copy protected recording the audio outputs are not muted.
Record with your recorder