Philips MCD700-37B - Manual (Page 11)

11
English
1 2
IMPORTANT!
– The type plate is located at the
bottom of the system.
– Before connecting the AC power
cord to the wall outlet, ensure that all
other connections have been made.
– Never make or change any
connections with the power switched
on.
Connecting the speakers
Connect the speakers to the SPEAKERS (8 Ω)
terminals with two speaker cables. Right
speaker to “R” and left speaker to “L”, red wire
to “+” and silver wire to “-”. Fully insert the
stripped por tion of the speaker wire into the
terminal as shown.
Connections
1 2
Notes:
– Ensure that the speaker cables are correctly
connected. Improper connections may damage the
system due to short-circuit.
– For optimal sound performance, use the supplied
speakers.
– Do not connect more than one speaker to any
one pair of +/- speaker jacks.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
AC power cord
Speaker
(right)
Speaker
(left)
AM antenna
FM
antenna
For MCD702
For MCD700
pg001-038_MCD700_37_Eng 2005.10.28, 13:31 11