Philips 27 in Color TV - Manual (Page 22)

22
O ver the next few pages you’ll learn how
to block channels and get a better under-
standing of the rating terms for certain pro-
gramming.
First, let’s start by learning how to set a per-
sonal access code:
1 Press the MENU button on the remote
to display the on-screen menu.
2 Press the CURSOR UP
▲ or DOWN
▼ button until the word FEATURES
is highlighted.
3 Press the CURSOR RIGHT ᮣ but-
ton to display the FEATURES menu
options.
4 Press the CURSOR UP
▲ or DOWN
▼ button until the words
AUTOLOCK are highlighted.
5 Press the CURSOR RIGHT ᮣ but-
ton. The screen will read, “ACCESS
CODE - - - - .”
6 Using the NUMBERED buttons,
enter 0, 7, 1, 1. “XXXX” appears on
the Access Code screen as you press
the numbered buttons.
“INCORRECT CODE” will appear
on the screen, and you will need to
enter 0, 7, 1, 1 again.
7 The screen will ask you to enter a
“New Code.” Enter a “new” 4 digit
code using the NUMBERED buttons.
The screen will then ask you to CON-
FIRM the code you just entered. Enter
your new code again. “XXXX” will
appear when you enter your new code
and then display the AutoLock menu
options.
Proceed to the next page to learn more...
S
ETTING
U
P AN
A
UTO
L
OCK
™ A
CCESS
C
ODE
VOL
Features
AutoLock
Format
Confirm Code
XXXX
Features
AutoLock
Format
New Code
- - - -
Features
AutoLock
Format
Access Code
XX - -
Features
AutoLock
Format
Access Code
XXXX
Features
AutoLock
Format
Access Code
- - - -
2
4
3
5
1
2
4
6
7
Main
Picture
Sound
Features
Install
Brightness
Color
Picture
Sharpness
Tint
More...
Main
Picture
Sound
Features
Install
AutoLock
Format
Features
AutoLock
Format
AutoLock
Block Channel
Setup Code
Clear All
Block All
Movie Rating
TV Rating
Off Stop Time
Channel
Activate
Display
AutoLock
Block Channel
Setup Code
Clear All
Block All
Movie Rating
TV Rating
OffStop Time
Channel
Activate
Display
Features
AutoLock
Format
Access Code
XXXX
Incorrect
Features
AutoLock
Format
New Code
XX - -
Parents - it isn’t possible for your child to
unblock a channel without knowing your
access code or changing it to a new one. If
your code changes, and you didn’t change
it, then you know it’s been altered by some-
one else and blocked channels have been
viewed.
H
ELPFUL
H
INT
NOTE: The 0,7,1,1 access code shown
on this page is the default code or a
way to reset the code when the current
access code is not known.