Tuning into a station – Blaupunkt SANTA CRUZ MP36 User Manual

Page 12

ANSK

GLISH

DEUT

SCH

FRAN

AIS

ALIAN

NEDERLANDS

VENSKA

ESP

AÑOL

PORTUGUÊS

Tuning into a station

There are various ways of tuning into a sta-

tion.

Automatic station seek tuning

Press the or button :.

The radio tunes into the next receivable sta-

tion.

Tuning into stations manually
You can also tune into stations manually.

Note:
You can only tune into stations manu-

ally if the convenient RDS function is

deactivated.

To change the set frequency in small incre-

ments,

briefly press the or button :.

To change the set frequency quickly,

press and hold down the or button

: for a longer period of time.



Switching REGIONAL on/off

Press the

MENU button 9.

Press the or button : repeated-

ly until "REG" appears on the display.

"OFF" or "ON" is displayed alongside

"REG".

To switch REGIONAL on/off,

press the or button :.
Press the

MENU button 9.

Switching the RDS function on/off
To switch the RDS functions AF and

REGIONAL on or off,

press and hold down the

TRA•RDS but-

ton 7 for longer than two seconds.

The RDS functions are active when RDS

lights up in the display.

Selecting the waveband/memory

bank

This device can receive programmes broad-

cast over the FM frequency range as well as

the MW and LW (AM) wavebands. There are

three memory banks available for the FM

waveband (FM1, FM2 and FMT) and one

for each of the MW and LW wavebands.
Six stations can be stored in each memory

bank.
To switch between the FM memory banks

(FM1, FM2 and FMT) and the MW and LW

wavebands,

briefly press the

BND•TS button 6.






Radio mode

02_SCruz_ValenciaMP36_eng.indd 41

07.02.2006 11:22:24 Uhr