Philips BlueTouch-Schmerztherapiegerät User Manual
Page 21
Possible reactions and side-effects
- It is normal for the skin to become a little red during treatment.
This skin redness is caused by increased blood circulation due to
the warmth of the BlueTouch Pain Relief Patch. This skin redness is
harmless and fades after the treatment has ended.
- In some cases tanning may be visible after treatment. This tanning is
caused by melanin concentrations in the skin and is a similar effect
to that caused by exposure to sunlight. It is harmless and fades away
within 48 to 72 hours. Postpone treatment until the tanning has
disappeared. To prevent tanning, resume treatment in a lower mode
and avoid excessive pressure on the BlueTouch Pain Relief Patch
during treatment, for example by sitting or lying on it or by leaning
heavily against it.
light and sound signals during use
overheating signal
1
If the sensor measures a too high temperature, the BlueTouch Pain
Relief Patch switches off for safety reasons.
2
If you try to restart the BlueTouch Pain Relief Patch within the
standard cooling-down time of 10 minutes after switching off, the
charging light flashes red three times.
3
After the standard cooling-down time of 10 minutes, the BlueTouch
Pain Relief Patch can be switched on again and the timer starts
counting down where it stopped.
Note: If treatment is not resumed within 2 hours, the timer is automatically reset.
Resetting signal
When the software of the BlueTouch Pain Relief Patch no longer responds
or another unexpected failure occurs, you can reset the BlueTouch Pain
Relief Patch.
1
Connect the BlueTouch Pain Relief Patch to the mains with the
adapter or connect it to a USB port of a computer.
2
Press the mode button for 5 seconds.
, First the first two rows of LEDs light up briefly. When they go out,
the third and fourth row light up briefly. When the third and fourth
row go out, the fifth and sixth row light up briefly. When the fifth and
sixth row go out, the seventh and eighth row light up briefly.
, After this the BlueTouch Pain Relief Patch is reset and works
normally again.
Battery level signals
When you press the mode button, the charging light shows the battery
status. The charging light goes out when the sensor senses skin contact or
when the device is switched off.
English
21