Beko WMA 657 S - Manual (Page 30)

EN 30
The water
being taken
in is directly
discharged.
Improper position of the
drain hose.
Connect the water draining hose as described
in the operation manual.
No water can
be seen in
the machine
during
washing.
This is not a problem. The
water level is not visible
from the outside of the
machine.
The door is
jammed.
Water level might be
above the lower level of
the door.
Run either the “Pump” or “Spin” program.
Machine might be heating
up the water or it may be
at the spinning cycle.
Wait until the process is over.
Due to electrical safety
mechanism, the door can
only be opened a few
minutes after the program
has stopped.
Wait until the process is over.
Machine fills
with water
when a
process is
cancelled.
Inside of machine may be
hot.
For safety reasons, water should be cycled in
and out a couple times.
Washing time
takes longer
than the time
specified in the
manual
Water pressure may be
low.
The machine will wait until there is a sufficient
amount of water, which may lengthen the
washing time to avoid poor washing results due
to insufficient water.
Supply voltage may be
low.
Washing time is lengthened to avoid poor
washing results when the supply voltage is low.
Input temperature of
water may be low.
Cycle time lengthens to heat up the water when
the input water is cold. Also, washing time can
be lengthened to avoid poor washing results.
There may be an
imbalance of laundry in
the machine.
The automatic spin correction system might
have been activated due to the unbalanced
distribution of the laundry in the drum.
The laundry in the drum may be clustered
(bundled laundry in a bag). Laundry should be
rearranged and re-spun.
No spinning is performed when the laundry is
not evenly distributed in the drum to prevent
any damage to the machine and to its
environment.
Number of rinses and/
or amount of rinse water
might have increased.
Water amount is increased to obtain a
better rinse and a rinse cycle is added when
necessary.