Vlm for vmware esx, esxi and vsphere – KEMP VMware ESX User Manual

Page 2

VLM for VMware ESX, ESXi and vSphere

Installation Guide

Copyright Notices

Copyright © 2002-2014 KEMP Technologies, Inc.. All rights reserved.. KEMP Technologies and the KEMP
Technologies logo are registered trademarks of KEMP Technologies, Inc..

KEMP Technologies, Inc. reserves all ownership rights for the LoadMaster product line including software
and documentation. The use of the LoadMaster Exchange appliance is subject to the license agreement.
Information in this guide may be modified at any time without prior notice.

Microsoft Windows is a registered trademarks of Microsoft Corporation in the United States and other
countries. All other trademarks and service marks are the property of their respective owners.

Limitations: This document and all of its contents are provided as-is. KEMP Technologies has made efforts
to ensure that the information presented herein are correct, but makes no warranty, express or implied,
about the accuracy of this information. If any material errors or inaccuracies should occur in this document,
KEMP Technologies will, if feasible, furnish appropriate correctional notices which Users will accept as the
sole and exclusive remedy at law or in equity. Users of the information in this document acknowledge that
KEMP Technologies cannot be held liable for any loss, injury or damage of any kind, present or prospective,
including without limitation any direct, special, incidental or consequential damages (including without
limitation lost profits and loss of damage to goodwill) whether suffered by recipient or third party or from
any action or inaction whether or not negligent, in the compiling or in delivering or communicating or
publishing this document.

Any Internet Protocol (IP) addresses, phone numbers or other data that may resemble actual contact
information used in this document are not intended to be actual addresses, phone numbers or contact
information. Any examples, command display output, network topology diagrams, and other figures
included in this document are shown for illustrative purposes only. Any use of actual addressing or contact
information in illustrative content is unintentional and coincidental.

Portions of this software are; copyright (c) 2004-2006 Frank Denis. All rights reserved; copyright (c) 2002
Michael Shalayeff. All rights reserved; copyright (c) 2003 Ryan McBride. All rights reserved.

Redistribution and use in source and binary forms, with or without modification, are permitted provided
that the following conditions are met:

Redistributions of source code must retain the above copyright notice, this list of conditions and the
following disclaimer

Redistributions in binary form must reproduce the above copyright notice, this list of conditions and the
following disclaimer in the documentation and/or other materials provided with the distribution.

THIS SOFTWARE IS PROVIDED BY THE ABOVE COPYRIGHT HOLDERS ''AS IS'' AND ANY EXPRESS OR IMPLIED
WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE ABOVE COPYRIGHT
HOLDERS OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR
CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR
SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR
OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
POSSIBILITY OF SUCH DAMAGE.

The views and conclusions contained in the software and documentation are those of the authors and
should not be interpreted as representing official policies, either expressed or implied, of the above
copyright holders..

Portions of the LoadMaster software are copyright (C) 1989, 1991 Free Software Foundation, Inc. -51
Franklin Street, Fifth Floor, Boston, MA 02110-1301, USA- and KEMP Technologies Inc. is in full compliance
of the GNU license requirements, Version 2, June 1991. Everyone is permitted to copy and distribute
verbatim copies of this license document, but changing it is not allowed.