Bertazzoni H366GGVNE - Manual (Page 22)

22
CLEANING THE APPLIANCE:
Never use abrasive cleaners
Before cleaning the appliance it should be disconnected from the power supply.
Cleaning the work surface: periodically clean the burner heads, the cast iron pan supports and the burner caps using
warm water.
Any spillage must always be removed as soon as possible using a rag.
If it become difficult to open or close a valve, do not force it, but immediately request the assistance of the
technical service personnel.
Cleaning the colored parts: The special finishing of the Bertazzoni Color ranges is realised with a particular painting
Follow these instructions for a correct maintenance of Your Bertazzoni range :
- Always use a very soft sponge or cloth.
- Keep the cloth clean rinsing it thoroughly
- Rub very lightly the surface, always with a circular movement. Do not insist on small area with a strong pressure.
- Use ONLY hot soapy water to remove grease or dirt
- NEVER use steel wool, abrasive cloth, abrasive cleaners or powders
- NEVER use any cleaner containing ammonia or abrasives
- Remove any splliage from the painted parts as soon as possible
- Do not permit to citrus or tomato juice to remain on stainless steel or colored surface for a long time, as citric acid
can permanently discolor the surfaces.
- To remove stubborn encrusted material, soak the area with hot towels to loosen the material
- Always wipe dry immediately to avoid water marks, with a clean soft cloth
-
If You are in doubt of using a detergent , try on a small area first.
Cleaning the enamelled parts: Enamelled parts should be cleaned frequently with soapy water. Never use abrasive
powder. Do not leave acidi or alkaline substances on the enamelled parts (such as vinegar, lemon juice, salt, tomato
sauce, etc.) and do not wash the enamelled parts while they are still hot.
Cleaning the stainless steel parts: Clean the parts with soapy water and dry them with a soft cloth. The shine is
maintained by periodically using specific stainless steel cream cleaner. Never use abrasive powders. Use specific
stainless steel cream cleaner to eliminate the glue remains afther the elimination of the blue plastic protection film on the
worktop after installation.
Cleaning the burner caps: Lift the burner caps from the burner heads and wash them in soapy water and dry
thoroughly. Before replacement on the burner head ensure that the holes are not clogged.
Cleaning the inner glass door: Clean the glass with warm soapy water using a sponge. A spatula can be used to
remove burner fat if used gently.
ATTENTION: while cleaning the door make sure to avoid any spillage in the venting holes on the top part of the door. To
clean inside the door it is necessary to disassemble the door through a service engineer.
ATTENTION: for further details about cleaning of the appliance, please contact your applliance retailer.
AFTER SALE SERVICE:
Please note here below details for after save service.
Refer to warranty certificate for warranty condiftions
Dealer /Importer: Name, address, phone
MANUFACTURER:
BERTAZZONI SPA
VIA PALAZZINA, 8 – 42016 – GUASTALLA (REGGIO E.) ITALY
Tel. +39 0522/226411 – telefax +39 0522/226440 –
http://www.bertazzoni-italia.com
SERVICE CENTERS
Name Phone