Blaupunkt COBURG RCR 168 - Manual (Page 14)

32
Please refer to the next section on "Storing
programme types".
b) Using the <<>> buttons on the rocker
switch
When PTY is switched on, you can
select a programme type using
buttons <<>>.
• Press << or >>; the programme type
selected last will be displayed for 3 se-
conds.
• During this period press >> (forwards)
or << (backwards) to select the desired
type.
• Press << or >> as many times as requi-
red.
If you would like to listen to a station with
the selected PTY,
•
press / to start the seek tuning
function.
If the radio is unable to find a station offe-
ring the selected programme type, the dis-
play will show "NO PTY" and a beep tone
will be emitted. The radio will select the sta-
tion which was tuned into before seek tu-
ning was activated.
Storing programme types
Each of the preset buttons 1-6 has been
assigned one programme type at the fac-
tory.
If desired, you can also replace these with
other available programme types.
To do so, make sure that "PTY" lights up in
the display.
•
If necessary, press the PTY button to
switch on the function.
• Select a programme type using buttons
<<>> and
• hold down the desired preset button (1-
6) until you hear a beep.
Now the selected programme type can be
recalled by pressing this preset as long as
"PTY" lights up in the display.
Scanning stations with PTY SCAN
Important: "PTY" must appear in the dis-
play.
•
Press SCA.
All of the stations in your current reception
area offering the selected programme type
will be scanned.
To switch off PTY-SCAN:
•
Press SCA again.
PTY priority
Situation:
PTY is switched on and lights up in the dis-
play.
No station offering the selected program-
me type can be found currently in your re-
ception range (with seek tuning or scan).
The set will switch back to the station pre-
viously tuned into.
As soon as it is possible to receive a pro-
gramme in the broadcast network with the
PTY selected, the radio will switch over to
the corresponding station for the duration
of the programme.
Example:
-
Station playing: NDR3.
- "PTY" lights up in the display.
- Programme type "POP" selected.
- Seek tuning is started.
- No station with "PTY-POP" can be
found.
- The display shows "NO PTY" and
- automatically switches back to NDR3.
- NDR2 airs a "PTY-POP" programme.
- The radio will switch to the linked stati-
on NDR2 for the duration of the "POP"
programme.
Cob/Portof/Colo gb® 30.05.2002, 10:16 Uhr 32