Philips SENSEO® Viva Café Premium Kaffeepadmaschine User Manual

Page 19

Put a bowl with a capacity of at least 1500ml under the spout to

collect the descaling mixture.

Press the 1-cup button q and the 2-cup button qq briefly at the

same time to start the descaling cycle.

, The CALC light and the light ring around the on/off button starts

flashing to indicate that the descaling cycle has started.

, Hot water comes out of the coffee spout in intervals. During the

descaling cycle, the machine stops descaling 3 to 4 times to let the

descaler mixture soak in and to heat up.

Let the machine complete the entire descaling cycle, which takes 4 to 5

minutes. Do not switch off the machine during the descaling cycle!

, When all the water in the water reservoir has been used up, the

descaling cycle is finished. The light ring around the on/off button

starts to flash rapidly.

Repeat the descaling procedure (steps 2 to 6) once. Replace the used

pod with another used pod to filter out the scale residue.

Rinse the water reservoir with tap water. Fill the water reservoir up

to the MAX indication with tap water and repeat steps 5 and 6.

Note: Do not refill the water reservoir with used hot water or the used

descaling mixture.

Fill the water reservoir with fresh tap water up to the MAX

indication again and repeat steps 5 and 6 once more.

Note: Always rinse the machine by letting it empty two full water reservoirs.

Remove the used pod and clean the pod holder after descaling to

prevent the sieve in the centre from getting clogged.

EnglisH