Philips SatinPerfect Epilierer - Manual (Page 12)

storage
- Put the trimming comb on the shave, trim and style attachment to prevent damage (HP6572
only).
- Store the appliance and the accessories in the luxury pouch.
replacement
All parts of the appliance can be replaced. If you need to replace one or more parts, go to your
Philips dealer or an authorised Philips service centre.
shave, trim and style attachment (HP6572 only)
If you use the shave, trim and style attachment two or more times a week, we advise you to replace
the shaving unit after one or two years or when it is damaged.
Environment
- Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 28).
guarantee and service
If you need service or information or if you have a problem, please visit the Philips website at
www.philips.com or contact the Philips Consumer Care Centre in your country (you find its
phone number in the worldwide guarantee leaflet). If there is no Consumer Care Centre in your
country, go to your local Philips dealer.
troubleshooting
This chapter summarises the most common problems you could encounter with the appliance. If
you are unable to solve the problem with the information below, contact the Consumer Care
Centre in your country.
Problem Cause Solution
Poor epilating
results
You move the
epilator in the wrong
direction.
Move the appliance against the direction of hair
growth, with the on/off button pointing in the
direction in which you move the epilator.
You place the
epilating head on the
skin at the wrong
angle.
Make sure that you place the epilating head on the
skin at an angle of 90° (see chapter ‘Using the
epilator’).
You have used a
cream or depilatory
cream prior to
epilation.
Make sure your skin is clean, entirely dry and free
from grease. Do not use any cream before you start
epilating.
The hairs are too
short.
Sometimes the hairs are too short to be caught. The
optimal length for easy removal of the hairs is 3-4mm.
The hairs that are not caught during this session will
be long enough to be removed when you epilate the
next time. You can also try to catch the hairs by
moving the appliance across the skin a few more
times.
EnglisH 12
4203.000.4504.1.indd 12 10-12-09 11:48