Bosch WTZ 1295P - Manual (Page 7)

7
Figure 17
q Turning the foot out (clockwise)
will raise the corner of the
appliance, turning the foot in
(counter-clockwise) will lower
the corner of the appliance.
When the corner of the
appliance is satisfactorily raised
or lowered, lock the
height-adjustable feet in place
by turning the lock nut
counter-clockwise until it locks
tightly against the pedestal
housing.
i It may be necessary to hold
the appliance foot with a
pair of pliers to keep it from
turning while tightening the
lock nut. It the foot does
turn, it will change the
height of the corner.
q After making preliminary
adjustments, press down on
each corner of the appliance to
make sure the unit does not
wobble. If it does wobble,
lower the foot on that corner
until the foot touches the floor
firmly.
3. For Washers: Fine tune the
leveling by placing a small load of
laundry in the machine, starting it
in spin cycle and then leveling the
appliance again.
i If the test spin cycle is manually
stopped before its completion,
then the door may remain locked
for 10 seconds.
Note: Correct adjustment of feet
(equal weight distribution to all feet)
is required to minimize vibration
and movement of the appliance
during operation.
4. Use the supplied 17mm openĆend
wrench to securely tighten both
locknuts for the front feet against
the pedestal. All locknuts must
be tightened firmly to prevent
the height adjustable feet from
moving during appliance use.
5. Slide the ball bearing rails on the
pedestal side to the front (see
Figure 18).
Figure 18
6. Replace the drawer by aligning it to
the drawer slides. Ensure slides of
pedestal and drawer are aligned
correctly (see Figure 19).
Correct
Incorrect
Figure 19
7. Close the drawer.
Ensure drawer slides are correctly
engaged by freely opening and
closing the drawer.
d CAUTION
Do not use the drawer as a step.
For problems with or service on your
pedestal contact BSH Home
Appliances. Contact information is
available in the Customer Service"
section of the appliance manual.