Bosch WTZ 1295P - Manual (Page 5)

5
Figure 9
4. Using the 6 mm Allen (Hex)
wrench, install the socket head cap
screws and flat washers (see
Figure 10).
Insert the square spacer between
the pedestal housing and the
appliance housing. Holding the
spacer in place, insert the bolt so it
passes through the flat washer,
pedestal housing, then the spacer,
and into the protruding threaded
bushing in the appliance base.
Repeat for all four bolts.
Make sure the webbed side of
each spacer is down toward the
base of the pedestal. The spacer
should fit up against the appliance
housing. Align the outer edges of
the spacer with the appliance and
pedestal housings. Loosely thread
all four bolts with the washers and
spacers in place before tightening
any of the bolts completely.
Figure 10
Use the wrench to HAND
TIGHTEN all screws (see Figure
10).
Helpful hint: Do not tighten any
screws completely until all are
started into their threads.
After all screws are hand tight, use
the wrench to tighten an additional
1/3 to 1/2 turn (see Figure 11).
Note: Tightening torque for the
pedestal screws is a minimum of
10 ftĆlb (14 N-m) to 13 ft-lb (18
N-m).
Figure 11
5. Install the four new feet that are
included with the pedestal. Screw
the feet into the threaded corner
holes in the base of the pedestal.
NOTICE
Use only the feet supplied
with the pedestal. Do not use
the feet that originally came with
the appliance.
Using the supplied 17 mm open
end wrench, tighten only the two
rear feet locknuts against the
pedestal housing (see Figure 12).
The front two feet should be hand
tightened only, so the appliance
can be leveled later.
Figure 12
d CAUTION
When lifting the appliance, be
careful not to allow it to slide
against the floor.
If the appliance slides, it may
cause injury or damage.
6. Lift the appliance and pedestal
assembly back to an upright
position (use of an assistant is
required) (see Figure 13).
d CAUTION
Avoid holding the appliance by
the pedestal when lifting it.
To avoid damaging the pedestal
do not use a dolly to lift or move
the appliance once the pedestal
is installed.
Figure 13
Step 7 below applies to washers.
For dryers go directly to step 8.
7. Remove the transport bolts.
d CAUTION
To avoid possible injury and damage
to the appliance and adjacent
surfaces, all four transport bolts
must be removed before using the
appliance. Retain the bolts for use
in any future transport (e.g. when
moving).
q Loosen all four bolts before
removing any of the bolts all the
way from the unit.
q Remove the bottom two bolts prior
to removing the top two bolts.