Beko BK 7641 T - Manual (Page 6)

Instructions for use
2
Electrical requirements
Before inserting the plug into the wall socket
make sure that the voltage and the
frequency shown in the rating plate inside the
appliance corresponds to your electricity supply.
• Take care to ensure that the plug remains
readily accessible. Do not use multiple adapter
bar or extension cable.
Warning! This appliance must be
earthed.
Repairs to electrical equipment should only be
performed by a qualified technician. Incorrect
repairs carried out by an unqualified person
carry risks that may have critical consequences
for the user of the appliance.
Transportation
instructions
1.
The appliance should be transported only
in upright position. The packing as supplied
must be intact during transportation.
2.
If during the course of transport the appliance,
has been positioned horizontally, it must not
be operated for at least 4 hours, to allow the
system tosettle.
3.
Failure to comply with the above instructions
could result in damage to the appliance, for
which the manufacturer will not be liable for.
4.
The appliance must be protected against
rain, moisture and other atmospheric influences.
Important!
•
Care must be taken while cleaning/carrying
the appliance not to touch
the bottom of the condenser metal wires at the
back of the appliance, as this
could cause injury to fingers and hands.
•
Do not attempt to sit or stand on top of your
appliance as it is not designed for such use.
You could injure yourself or damage the
appliance.
• Make sure that the mains cable is not caught
under the appliance during and
after moving, as this could damage the cable.
•
Do not allow children to play with the
appliance or tamper with the controls.
Installation instructions
1. Do not keep your appliance in a room where
the temperature is likely to fall below 10 ° C
(50 ° F) at night and/or especially in winter,
as it is designed to operate in ambient
temperatures between +18 and +43 ° C (50
and 90 ° F). At lower temperatures the appliance
may not operate, resulting in a reduction in the
storage life of the food.
2.
Do not place the appliance near cookers
or radiators or in direct sunlight, as this will
cause extra strain on the appliance's functions.
If installed next to a source of heat or freezer,
maintain the following minimum side clearances:
From Cookers 30 mm
From Radiators 300 mm
From Freezers 25 mm
3.
Make sure that sufficient room is provided
around the appliance to ensure free air
circulation.
• Put the back airing lid to the back of your
refrigerator to set the distance between the
refrigerator and the wall.
4.
The appliance should be positioned on a
smooth surface. The two front feet can be
adjusted as required.To ensure that your
appliance is standing upright adjust the two
front feet by turning clockwise or anti-clockwise,
until firm contact is secured with the floor.
Correct adjustment of feet prevents excessive
vibration and noise.
5.
Refer to "Cleaning and Care" section to
prepare your appliance for use.
GB